331 Full Wrap Clamp For Nominal Pipe Size

331 Full Wrap Clamp For Nominal Pipe Size

  • LOCKING WASHER PLATE: Type 304, 10 gauge stainless steel. Locks into position for easy tightening of nuts.
  • BOLT RECEIVERS: Type 304, 8 gauge stainless steel. MIG welded to receiver bar and fully passivated*. Leading edge is rounded to permit locking washer plate to slide into position easily.
  • SHELL: Type 304 stainless steel.
  • BOLTS: Type 304 stainless steel, 5/8" rolled NC thread in sizes 4" and larger (1/2" in sizes below 4"). Bolts are MIG welded to bolt bar and fully passivated*.
  • NUTS: Type 304 stainless steel, heavy hex. PTFE coated to prevent galling.
  • BOLTS AND RECEIVER BARS: Type 304, 12 gauge stainless steel. TIG welded to shell to form a strong fusion and fully passivated*
  • WASHERS: Nylon
  • GASKET: ASTM D 2000 AA415 rubber is specially formulated for water service and has antioxidant/antiozonant agents to increase shelf life.
  • ARMOR: Type 304 stainless steel, heavy gauge, molded into gasket to prevent "hanging-up" during installation.
  • PRESSURE RATING: 125 psi through 12" pipe size. 75 psi over 12" pipe size.
  • TEMPERATURE: -20 degrees F to 212 degrees F.
  • CLAMPETTE Available In 6", 8", 10", 12", 16", 20", 24" and 30" Lengths.

*Clamps are chemically cleaned after welding to maintain the original passive state of the stainless steel.

 

Back to Top
Copyright © 2004-2022 Matco-Norca. Website Design and Development by AIMG. Site Map.